• Olesen Serrano posted an update 1 year, 3 months ago

    Installed by pros, a whole house could be installed or "hung" in a day. Taping, spackling and sanding is going to take on average 4 to 5 more work days until it really is ready for painting. After some practice, any homeowner can install drywall and attain a satisfactory result.

    If you have the opportunity to watch someone either hanging the drywall or actually do the taping and spackle work it could be a great aid in seeing that they get it done. Drywall also comes in several unique thicknesses there a a number of different types for special applications. One of the most commonly seen drywall is a 1 / 2 inch thick and is also employed in most areas of any home. Walls and ceilings both use 1 / 2 inch material. Inside my state, five eighths inch thick drywall or 1 / 2 inch fire code drywall is required in attached garages well as over a house boiler or furnace located in a basement. Garages and boiler room drywall requires simply a single coat of tape and spackle termed as a fire coat, to prevent a fire from penetrating the drywall at the seams and screws.

    Bathrooms are usually considered wet areas and therefore special green or water repellent drywall is employed in any wet area. If tile will likely be applied then your drywall is really a special coarse rough surface cement drywall board. Drywall can be obtained with lead linings for X-ray rooms, special insulation paper backing, printed decoration faces, plus a many other special applications.

    Standard sheets of drywall come in four foot widths but lengths differ from eight feet to sixteen feet as common sizes. Longer special order lengths can be found. Many box stores and lumber yards carry lengths up to twelve feet with fourteen and sixteen foot sheets being ordered. Homeowners typically will choose eight foot lengths due to the easy handling the fabric but with a twelve foot wall, that causes an additional vertical four foot joint that must be taped and spackled. A twelve foot sheet would reach corner to corner. Do that in a entire house and you’re looking at numerous feet more work taping and sanding. That converts into many extra hours of training.

    Installing drywall is generally a two person job simply because handling the sheets is very cumbersome. When installing drywall on a ceiling a two person crew isn’t sufficient. With a single person holding each side of the sheet the next installing either the nails or screws to lock it towards the studs or rafters, keeping the sheet tight for the wall and inline using the other sheets is a chore. I know of experienced installers hang five eighths inch twelve foot sheets alone but this nevertheless it takes many years of practice. Renting a drywall lift that could raise and hold a sheet available will allow you to work alone.

    It is a much preferred practice to use screws when installing drywall on ceilings. Screws come in various lengths to match the conditions but inch and five eights long is the most common size used. Screws are available in galvanized and stainless finishes at the same time.

    To learn more about

    guide to bending drywall view the best site.